In some large-screen occasions, the in-line splicing screen installation is often used, because the installation space is small, and embedding the screen into the wall can greatly reduce the occupation of the deep space, so that the screen and the wall are flat, so that The whole display is better, so how can this effect be achieved?
First, how to embed?
The in-line splicing screen is usually embedded in the real wall or the false wall. For example, there is a small control room behind the wall. You can directly dig a space on the wall according to the size of the splicing screen used. . If it is a keel or partition of the later decoration, it is usually not able to bear the weight, so it is installed and fixed behind it, and the screen is embedded in the decoration board.
Second, what do you pay attention to inline installation?
It should be noted that before the inlay, we must design the number of splicing used, the size after splicing, the height from the ground, and whether there is any static floor, etc., so we must consider it in advance to confirm the reserved space. Long and wide.
At the same time, the space around the reserved space is usually about 2 cm longer than the length and width of the embedded splicing screen. The purpose is to facilitate the installation of the technician, so that the frame of the screen does not touch the wall to prevent the screen from being crushed. After the post-installation is completed, you can simply wrap around the perimeter.
In some cases, there will be a case where the screen is installed first, and then the side of the decoration is covered. At this time, it is necessary to pay attention to it, because there is often a collision with the screen, which causes the screen to break.
Third, how to install?
The most common installation method for the in-line splicing screen is the bracket, which is available in single or double layers, depending on the site. In fact, compared to the traditional installation, the difficulty of the in-line installation lies in the attachment of the fixed bracket and the reserved position, which is related to the effect of the entire splicing. Our suggestion is to assemble the bracket first, and then decorate it, so that the reserved display position will be more accurate, especially in some occasions with a large number of stitching.
After all, the purpose of the in-line splicing screen installation is to reduce the space occupancy and increase the overall aesthetics after splicing. This is mainly used in some conference rooms, exhibition halls, etc. At present, our company has accumulated rich experience in this area. , installed dozens of cases.
